| Turbine Engine: full power ... LOUD |
|
|
EGT or exhaust gas temperature in degrees Celsius, measured just after the last stage of the turbine, which is just behind the second green steel frame holding the engine. Next is RPM. This engine has basically one rotating shaft, and you can just barely see the 1st stage compressor blades moving on shutdown. Engine RPM is of this common shaft, upon which all compressor and turbine stages are mounted.5,000 rpm is idle speed for this engine. Last, on the right, is lube oil pressure, in pounds per square inch. These engines have roller bearings, not journal bearings like a car engine, so oil pressure is mainly an indication of oil flow. A lot of flow is needed, because the oil is used as a coolant for the main bearings. The engine will run with no oil pressure, except the bearings will overheat, so monitoring of oil flow is very important. QUOTE THIS ARTICLE ON YOUR SITE To create link towards this article on your website, copy and paste the text below in your page. Preview :
Turbine Engine: full power ... LOUD Thursday, 31 December 2009 This is more film of the GE LM1500 gas turbine engine running at the S&S Turbines open-air test cell. All the noise in the beginning is made by the... |




